this drill was purchased by jimmy diresta then given to hand tool rescue, he then shipped it to me to see if I could get it to run right, so that is what goes on in this video
.hand tool rescue , https://www.youtube.com/watch?v=FkOlgsF5sAE
Jimmy Diresta https://www.youtube.com/watch?v=OVd4rytwhm0
.hand tool rescue , https://www.youtube.com/watch?v=FkOlgsF5sAE
Jimmy Diresta https://www.youtube.com/watch?v=OVd4rytwhm0
Wasn't the section of exhaust with the port in the yellow Diresta box? I thought I saw it when Hand Tool unboxed it. Also, the washer under the flywheel nut is visible in that video as well.
Next step:Fuel injection..,turbocharger,…Nitro..😀
Just need some parts out the antique model airplane junk box. A clunk and hose, a pressure nipple. Treat it like an old control line nitro powered airplane. The piece you were fooling with earlier was a inline fuel filter. It will unscrew in half to clean a tiny brass screen.
I had one of these back in the 70’s. It was made by Drillgine. We got it to start after a while. It was pretty useless.
Hahaha booooooooooo shite
Brass connector may have a copper seal or o-ring
I once had a generator like this,by the time it was started you were nice and toastie on a cold morning.
Get a threaded nipple at a local hobby shop for a fuel fitting
Is the pressure port off the crankcase its a two stroke no ?smear a tint bit of jb weld around ot as you press it in
Part 3???